Company Blog 2025-06-15

What Are The Charcoal Making Machine Faults?

2025-06-15Charcoal Making Machine

Back to Article
List

The majority of customers invest in charcoal making production line is to achieve better benefits. And the charcoal making machine as the important equipment of the whole production line. Only through reasonable operation can ensure better production of mechanism charcoal. Failure of charcoal making machine equipment may lead to problems with its finished charcoal. It will also affect the production efficiency of the charcoal machine.

What Are The Charcoal Making Machine Faults?

The briquette machine does not produce charcoal rods: the propellers are not the same, the moulding sleeve is worn out, and the heating temperature is too high or too low. Secondly, if the moisture in the raw material is too big or too small, it will lead to no charcoal stick. When the briquette machine works normally, the formed charcoal rods are even, dark brown, even hardness, smooth surface, no cracks, smooth surface of the centre hole, which can fully contact the air for easy combustion.

Surface cracks: If the water content of the charcoal stick is too much, there will be a lot of transverse cracks. If the water content is too small, longitudinal cracks will appear. Another reason is that the heating temperature causes excessive softening of the wood raw material. This leads to insufficient supply of raw material in the bar making machine, and cracks will also appear. The solution can be to increase the screw diameter. Or polish the screw wall. Increase the stall distance between the screw threads.

Bad hardness: if the charcoal stick cross-section is bright and shiny. But the hardness is not good, mainly because the spiral is too steep at the beginning again.

Low density or loose sawdust: due to wear at the bottom at the tip of the screw propeller shaft. Or thickened again by additional welding. If the shaft tip is not working properly it can also lead to the above problems.

Bent charcoal sticks: Excessive moisture in the raw material.

Gas coming out of the discharge opening: mainly due to insufficient supply of raw material, too much moisture in the raw material or insufficient heating temperature etc.

Therefore. According to the user's reasonable solution to ensure better production of charcoal making machine equipment. All the charcoal making machine should be operated reasonably in order to produce mechanism charcoal better. So as to improve the production efficiency and quality of the product carbon rod.