FAQS Of Making Charcoal Briquette Machine

Charcoal briquette making machine is the most important equipment in charcoal production line. It is responsible for the bar making and moulding in the whole production line. Only after forming the qualified sticks can go through the next step of carbonisation. In the process of charcoal production, the charcoal briquette machine is also inevitable problems. The following is a detailed introduction to the common problems and solutions of charcoal briquette making machine.

 

When you start to process and make charcoal, the carbon rods are not shaped solution:

1. Firstly, you need to check the propeller of the charcoal briquette making machine. Check whether there is any problem with the angle of the propeller butt welding. If the raw material is ultra-fine powdery material, you need to add a little large particles of sawdust. This will increase the friction strength of the propeller. Then the carbon rods can be extruded by high temperature and high pressure.

2. The heating temperature of the charcoal briquette making machine is too high or too low. Adjust the temperature according to different raw materials.

3. if the grooves on the inner sleeve of the heating ring and the grooves of the heating cylinder are misaligned, the carbon rods will not be produced. The carbon rods will not be produced. Therefore, it is necessary to reinstall the heating cylinder inner sleeve.
 

The charcoal briquette making machine does not produce carbon rods at the beginning of use:

1. Firstly, check the moisture content of raw material is too low. If the moisture content of the raw material is too low, no carbon will be produced. The moisture content of biomass raw material should be controlled at 15%-20%. 2) The moisture content of wood raw material is too low.

2. the moisture content of the raw material of wood is too large. That is, the raw material is too wet. If the sawdust is too wet, it is easyto be clogged. It will not be able to produce carbon rods, so the raw material needs to be dried again.
3. Thruster angle. If the angle of the pusher is <20°. The carbon will not be shaped. The angle of the pusher needs to be adjusted.

4. Whether there is too much grease in the raw material. If the grease is too large, the carbon rod will not come out easily. It will also send clogging.

5. Charcoal briquette making machine heating coil circuit problem. Check whether the electric heating ring is short circuit. It needs to be repaired in time.


Therefore. Friends who want to buy charcoal briquette making machine. Before you start production, you must listen to the guidance and training of the manufacturer's technicians. Thus, you can quickly take charge of the charcoal making technology.

• Perv: Back To List
• Newxt: What Are The Charcoal Making Machine Faults?